DMX signal board for LEDStrip Digital WS2812 and compatible (to be welded)
€15.00
€12.50
In stock
SKU
DMX_TO_WS2812_SOLDERING
DMX signal board for LEDStrip Digital WS2812 and compatible. (RGB and RGBW)
Signal output with pattern repetition to be used up to 850 Pixels.
4 pixel modes X1 X2 X3 or 12 channel mode (program)
- Buy 6 for €14.00 €11.67 each and save 7%
- Buy 24 for €12.00 €10.00 each and save 20%
DMX TO WS2812 (268.3KB) 
DMX signal board for LEDStrip Digital WS2812 and compatible.
To be welded.
Signal output with pattern repetition to be used up to 850 pixels (28m in 30L/m)
TECHNICAL SPECIFICATIONS
-
- DMX modes and address selected via dip switch.
- DMX 512 input on a 3-pin connector.
- VCC power input (led stip), +5v and ground.
- LED strip VCC output, ground and signal.
- DMX address setting on dip 1 to 9
- LED type setting : RGB or RGBW on DIP 10 (except mode 4)
- setting of pixel mode X1 X2 X3 or 11 channels program mode on DIP 11 and 12
- usable with LED strip 12V.
- Power supply: from +5Volts to +24 Volts
- Module consumption: min 18 ma (without LED strip)
- Dimensions : 39mmX33mm
Write Your Own Review
