DMX board for 2 bipolar stepmotors
€25.00
€20.83
In stock
SKU
DMX_TO_STEPMOTOR
!!!!NEW RELEASE !!!!
DMX board for 2 bipolar stepmotors with sensor input for one limit switch.
24V 1,5A max per motor.
Now with specialized IC A4988 stepmotor driver.
Simplified board parameter setting with DMXTools via the board's USB port
Lifetime firmware updates (via DFU on USB port)
!!!!NEW RELEASE !!!!
DMX board for 2 bipolar stepmotors with sensor input for one limit switch.
24V 1,5A max per motor.
Now with specialized IC A4988 stepmotor driver.
Simplified board parameter setting with DMXTools via the board's USB port
TECHNICAL SPECIFICATIONS :
- Power supply : DC +3.6 to +36 Volts
- Consumption : 16mA for module alone (without motor)
- Dimensions : 50 X 50 X 11 mm
- Motor : 2 outputs for bipolar motor at constant voltage max 24Volt and Max 1.5A(depending on board supply voltage) ,step resolution: Full,1/2,1/4,1/8,1/16
- Sensor : 2 TTL inputs with internal pull-up resistor and 3.3V output
4 MODES:
MODE 1 : setting via DMXTools
2 DMX channels :
Channel 1 : Motor 1 position
Channel 2 : Motor 2 position
MODE 2 : setting via DMXTools
4 DMX channels :
Channel 1: Motor 1 position
Channel 2 : Motor 1 fine position
Channel 3 : Motor 2 position
Channel 4 : Motor 2 fine position
MODE 3 : setting via DMXTools
2 DMX channels :
Channel 1 : Motor 1 rotation speed
Channel 2 : Motor 2 rotation speed
The motor is stopped at the midpoint of the DMX value, i.e. 127 or 50%.
Below 50% the motor rotates clockwise, above 50%, counter-clockwise.
At 0% the motor runs at maximum speed clockwise, and vice versa at 100% the motor runs at maximum speed counter-clockwise.
Write Your Own Review
