Receiver Module DMX HF 2.4GHz V4 for LEDSTRIP RGBW

PACK INCLUDING HF MODULE + STANDARD REMOVABLE ANTENNA

TECHNICAL SPECIFICATIONS :

• DMX HF Module  to control LEDSTRIP RGB or any other device up to 8 Amperes on 4 channels.
  
• With 6 DMX channels you can independently control your 4 channels plus a general dimmer channel and a stroboscope channel.
• 6 DMX channels (4/8 channels mode or 1 channel on EXPERT Assignation)
• Power supply : from  +5Volts to +16 Volts
• Power consumption: 22mA – 50mA, 4X 8 Amperes per channel for the power card.
• Dimensions : 42mm X 25mm X 27 mm (without antenna)
• HF Sensitivity (2.4Ghz) : -90db
• Frequencies : 31
• Possible Universes : 31 (15872 DMX channels)
• W2.4EC-DMX-A AND B protocol

The use of HF ELECTROCONCEPT products changes nothing to the use of your DMX devices.

The technology used here allows for a full transparency among your devices.

The 512 channels are sent. A frames synchronization allows for no latency between the emitter and the receiver.

Every receiver has a memory allowing the receiver to send back the last value received if there’s a loss of HF connection.

All of your products using receivers to integrate can be used, as before, wired. The receiver has a Stand-by mode which activates if a DMX connection is detected at the device’s input. The range depends on environment, about 30M in hostile environment (between walls), and about 600M outdoor.

Every HF receiver is « assigned » to a DMX universe, originally universe 1 .

At start, the receiver is permanently scanning frequencies until finding the universe to which it is assigned.

Originally your products are delivered in order to operate on universe 1, and the emitters emits in frequency 1.